Raised-panel steel
Carriage house
Modern flush
Full-view glass
LiftMaster openers
Chamberlain openersFull 25-point door and opener safety check with every visit - springs, cables, rollers, tracks, and your LiftMaster or Chamberlain opener included
You get a price before we start. It does not change when the truck arrives.
Get your free estimateGarage Door Before & After in Austin, TX
Photos of finished work tell you more than any promise we could make. Below are real scenarios we handle across Austin, from Hyde Park to Circle C, and what changed after the repair. Every job follows the same rule: a written price before the first tool comes off the truck, and the 365-Day Done Right Promise in writing before we leave.
Styles & brands we work with






Recent Transformations
Torsion Spring Replacement in Mueller
Before
AfterThe problem: a torsion spring, the horizontal coil above the door that does most of the lifting, snapped at 7:15 on a Monday morning. The door wouldn’t budge, and the car was trapped inside. We replaced both springs as a matched pair, which matters because the old spring that hadn’t snapped was just as worn. Result: a balanced door that lifts smoothly, without the cabinet-shaking rattle it had before. Spring replacement typically runs $150-$290 depending on spring type, and the customer saw the exact number before we started.
Lift Cable Repair in South Austin
Before
AfterA frayed steel lift cable had started to unravel like a cheap guitar string, leaving the door cocked at an angle and one corner grinding against the track. Left alone, that cable snaps under full tension and the door slams down. We replaced both cables, not just the damaged one, and re-routed them clean through the pulleys. The door now rises evenly and quietly, and more importantly, it’s not hanging by a thread.
Garage Door Off Track in Round Rock
Before
AfterThis one came in through a Sunday call: the bottom roller had popped out of the track after years of the door being forced open a little too hard. The door was wedged at a 20-degree angle, and the customer had a flight in three hours. We reset the rollers, checked the track for bends, and tightened the bolts that had worked loose. The door rolls straight again. A quick note: if a door comes off track, don’t try to muscle it back in place while the springs are under tension. Call a trained tech.
Broken Extension Spring on a Craftsman Door in Pflugerville

Extension springs run along the horizontal tracks on each side, and when one lets go on an older Craftsman door, the imbalance is immediate. The door shot up about eight inches and stopped, stuck because the second spring was doing double duty. We replaced the pair with springs rated for the door’s exact weight and height, then retested the balance three times. The difference: the customer can lift the door with one hand again, which is the test we always leave behind.
Full Door Realignment in Westlake Hills

A Genie opener had been yanking a slightly misaligned door for years, wearing the hinges unevenly and leaving one side of the door a half-inch higher than the other. The photo doesn’t fully capture the sound it made, a grinding creak you could hear from the kitchen. We squared the tracks, replaced the worn hinge plates, and reset the opener’s travel limits. The door now opens and closes with the kind of smooth motion a Genie opener is actually designed for.
Spring and Cable Combo on a Clopay Door in Cedar Park

Some jobs come in pairs. This Clopay door had a torsion spring that had been out of spec for a while, and the extra strain eventually started shredding the lift cable on the left side. We replaced the springs, both cables, and the worn roller bearings, then ran the door through fifteen full cycles while the customer watched. The written price for all of it was on the table before the first part came off. That’s how every combo job goes, no exceptions.
Want Results Like These?
If your door is making a noise it didn’t make last month, or it’s sagging, stuck, or slow to lift, don’t wait for the 7 a.m. Monday failure. Call Marlow Garage Door Repair Austin at (361) 320-8872 and you’ll talk to a live person, not a recording. We’ll give you a written price before any work begins, and you can book online and track your tech on the way. The invoice won’t surprise you, because the number matches what you agreed to.
Written by Jaylen Ross, Owner at Marlow Garage Door Repair Austin, serving Austin since 2002.
See the difference
Before
After
Before
After
Before
After